User's Manual

Chapter 2: Installing and Configuring the EMX Device
21
10. To verify whether all settings are correct, type the following
commands one by one. Current network settings are displayed.
Command
Description
show network
Show network parameters.
show network ip
all
Show all IP configuration
parameters.
show network
wireless details
Show all wireless parameters.
(Perform this command only
when you enable the wireless
mode.)
Tip: You can also type "show network wireless" to display a
shortened version of wireless settings.
11. If all are correct, type exit to log out of the EMX. If any are
incorrect, repeat Steps 7 to 10 to change any network settings.
The IP address configured may take seconds to take effect.