User's Manual

Chapter 10: Using the Command Line Interface
282
Setting the X Coordinate
This command syntax specifies the X coordinate of an environmental
sensor.
config:#
externalsensor <n> xlabel "<coordinate>"
Variables:
 <n> is the ID number of the environmental sensor that you want to
configure. The ID number is assigned and shown in the EMX web
interface. It is an integer between 1 and 16.
 <coordinate> is a string comprising up to 24 ASCII printable
characters, and it must be enclosed in quotes.
Example
The following command sets the value "The 2nd cabinet" to the X
coordinate of the environmental sensor with the ID number 4.
config:#
externalsensor 4 xlabel "The 2nd cabinet"
Setting the Y Coordinate
This command syntax specifies the Y coordinate of an environmental
sensor.
config:#
externalsensor <n> ylabel "<coordinate>"
Variables:
 <n> is the ID number of the environmental sensor that you want to
configure. The ID number is assigned and shown in the EMX web
interface. It is an integer between 1 and 16.
 <coordinate> is a string comprising up to 24 ASCII printable
characters, and it must be enclosed in quotes.
Example
The following command sets the value "The 4th row" to the Y coordinate
of the environmental sensor with the ID number 4.
config:#
externalsensor 4 ylabel "The 4th row"