User's Manual

Chapter 2: Installing and Configuring the EMX Device
19
 For the static IPv4 configuration, configure these parameters.
To set
Use this command
Static IPv4
address
network ipv4 ipAddress <ip
address>
where <ip address> is the IP address
you want to assign.
Subnet mask
network ipv4 subnetMask
<netmask>
where <netmask> is the subnet mask.
Gateway
network ipv4 gateway <ip
address>
where <ip address> is the IP address
of the gateway.
Primary DNS
server
network ipv4
primaryDNSServer <ip
address>
where <ip address> is the IP address
of the primary DNS server.
Secondary
DNS server
(optional)
network ipv4
secondaryDNSServer <ip
address>
where <ip address> is the IP address
of the secondary DNS server.
f. If you enabled IPv6 in the earlier step, configure the IPv6
network parameters.
To set
Use this command
IP
configuration
method
network ipv6
ipConfigurationMode <mode>
where <mode> is either automatic for
auto configuration (default) or static for
specifying a static IP address.
Tip: To override the DHCP-assigned IPv6 DNS servers with those
you specify manually, type this command:
network ipv6 overrideDNS <option>