User's Manual

Chapter 2: Installing and Configuring the EMX Device
18
To set
Use this command
IP protocol
network ip proto <protocol>
where <protocol> is v4Only for
enabling IPv4, v6Only for enabling
IPv6 or both for enabling both IPv4 and
IPv6 protocols.
IP address
returned by
the DNS
server
network ip
dnsResolverPreference
<resolver>
where <resolver> is preferV4 for IPv4
addresses or preferV6 for IPv6
addresses.
e. If you enabled the IPv4 protocol in the previous step, configure
the IPv4 network parameters.
To set
Use this command
IP
configuration
method
network ipv4
ipConfigurationMode <mode>
where <mode> is either dhcp for auto
configuration (default) or static for
specifying a static IP address.
 For the IPv4 DHCP configuration, configure this parameter.
To set
Use this command
Preferred host
name
(optional)
network ipv4
preferredHostName <name>
where <name> is the preferred host
name.
Tip: To override the DHCP-assigned IPv4 DNS servers with those
you specify manually, type this command:
network ipv4 overrideDNS <option>
where <option> is enable or disable. See the table below for the
IPv4 commands for manually specifying DNS servers.