User's Manual

Chapter 10: Using the Command Line Interface
248
Setting the IPv6 Address
After selecting the static IP configuration mode, you can use this
command syntax to assign a permanent IP address to the EMX device.
config:#
network ipv6 ipAddress <ip address>
Variables:
 <ip address> is the IP address being assigned to your EMX device.
This value uses the IPv6 address format.
Example
The following command assigns the static IPv6 address
"3210:4179:0:8:0:800:200:417/128" to the EMX device.
config:#
network ipv6 ipAddress 3210:4179:0:8:0:800:200:417/128
Setting the IPv6 Gateway
After selecting the static IP configuration mode, you can use this
command syntax to specify the gateway.
config:#
network ipv6 gateway <ip address>
Variables:
 <ip address> is the IP address of the gateway. This value uses the
IPv6 address format.
Example
The following command sets the gateway to 500:0:330:0:4:9:3:2.
config:#
network ipv6 gateway 500:0:330:0:4:9:3:2