User's Manual

Chapter 2: Installing and Configuring the EMX Device
16
b. For the wired network mode, you may configure the LAN
interface settings. In most scenarios, the default setting (auto)
works well and should not be changed unless required.
To set
Use this command
LAN interface
speed
network interface
LANInterfaceSpeed <option>
where <option> is auto, 10Mbps, or
100Mbps.
LAN interface
duplex mode
network interface
LANInterfaceDuplexMode
<mode>
where <mode> is half, full or auto.
Tip: You can combine multiple commands to configure multiple
parameters at a time. For example,
network interface LANInterfaceSpeed <option>
LANInterfaceDuplexMode <mode>
c. For the wireless network mode, you must configure the Service
Set Identifier (SSID) parameter.
To set
Use this command
SSID
network wireless SSID <ssid>
where <ssid> is the SSID string.
If necessary, configure more wireless parameters shown in the
following table.
To set
Use this command
BSSID
network wireless BSSID
<bssid>
where <bssid> is the AP MAC
address.