User's Manual

Chapter 10: Using the Command Line Interface
239
Setting the EAP Parameters
When the wireless authentication method is set to EAP, you must
configure EAP authentication parameters, including outer authentication,
inner authentication, EAP identity, password, and CA certificate.
Setting the Outer Authentication
This command syntax determines the outer authentication protocol for
the EAP.
config:#
network wireless eapOuterAuthentication <outer_auth>
Variables:
 The value of <outer_auth> is PEAP because EMX only supports
Protected Extensible Authentication Protocol (PEAP) as the outer
authentication.
Example
The following command determines the outer authentication protocol for
the EAP authentication is Protected Extensible Authentication Protocol
(PEAP).
config:#
network wireless eapOuterAuthentication PEAP
Setting the Inner Authentication
This command syntax determines the inner authentication protocol for
the EAP.
config:#
network wireless eapInnerAuthentication <inner_auth>
Variables:
 The value of <inner_auth> is MSCHAPv2 because EMX only
supports Microsoft's Challenge Authentication Protocol Version 2
(MSCHAPv2) as the inner authentication.
Example
The following command determines the inner authentication protocol for
the EAP authentication is MSCHAPv2.
config:#
network wireless eapInnerAuthentication MSCHAPv2