User's Manual

Chapter 10: Using the Command Line Interface
231
Example 2 - In-Depth Security Information
More information is displayed when typing the show security details
command.
Configuring the EMX Device and Network
To configure the EMX device or network settings through the CLI, you
must log in as the administrator.
Entering the Configuration Mode
You must enter the configuration mode since configuration commands
function in the configuration mode only.
To enter the configuration mode:
1. Ensure you have entered the administrator mode and the # prompt is
displayed.
Note: If you enter the configuration mode from the user mode, you
may have limited permissions to make configuration changes. See
Different CLI Modes and Prompts (on page 215).
2. Type config and press Enter. The config:# prompt appears,
indicating that you have entered the configuration mode.
3. Now you can type any configuration command and press Enter to
change the settings.
Important: To apply new configuration settings, you must issue the
"apply" command before closing the terminal emulation program.
Closing the program does not save any configuration changes. See