User's Manual

Chapter 2: Installing and Configuring the EMX Device
11
Connecting the EMX to a Power Source
If your EMX device is designed to use a cable retention clip, install the
clip before connecting a power cord. A cable retention clip prevents the
connected power cord from coming loose or falling off.
The use of cable retention clips is highly recommended for regions with
high seismic activities, and environments where shocks and vibrations
are expected.
To connect the EMX device to a power source:
1. Install the cable retention clip by inserting both ends into the tiny
holes on two hexagon screws adjacent to the power socket.
2. Plug one end of the Raritan-provided power cord into the power
socket, and press the cable retention clip toward the power cord until
it holds the cord firmly.
3. Connect the other end of the power cord to an appropriate power
source.
Configuring the EMX
To configure the EMX device:
1. Connect the EMX device to a computer via a serial or USB
connection.