Owner's manual

72 COMMANDCENTER SECURE GATEWAY ADMINISTRATOR GUIDE
For IPMI Power Control connections:
Figure 69 Configuring an IPMI Power Control Interface
1. Type the IP Address or Hostname for this interface in the IP Address/Hostname field.
2. Type a UDP Port for this interface in the UDP Port field.
3. Click the Authentication drop-down menu and select an authentication scheme for
connecting to this interface.
4. Type a check interval for this interface in the Check Interval (seconds) field.
5. Type a username for this interface in the Username field.
6. If necessary, type a password for this interface in the Password field.
7. Click OK add the interface to the node. You will be returned to the Add Node or Node
Profile screen.
Results of Adding an Interface
After adding an interface, it will appear in the Interfaces table and the Default Interface drop-
down menu of the Add Node or Node Profile screen. You can click the drop-down menu to
select the default interface to use when making a connection to the node.
After changes to the Add Node or Node Profile screen are saved the name of the interface(s) will
also appear on the Nodes list, nested under the node it provides access to.