Owners manual

BED RAILS - UNIVERSAL

1. Read and understand instructions

completely before beginning installation.

2. Screw All-Thread Studs into Rail

Brackets on each end of bar (pointed

end of stud should be faced down).

3. Carefully place Rail in desired position

on pick-up bed (3a). Tap lightly with

your hand to mark where holes will be

drilled (3b).

Components:

Rail

Qty 2

Plastic Oval

Gasket

Qty 4

Hardware:

All-Thread

Studs

Qty 4

3/8” DRILL BIT DRILL

RATCHET

CENTER

PUNCH

RUBBER

MALLET

Tools Required:

Note: When installing the Rails, all hardware must be left loose until all the items are attached.

Hex Nuts

Qty 4

Flat

Washers

Qty 4

Lock

Washers

Qty 4

Rev 5