Installation Manual

CAB MOUNT BOLT

4. Install the Rear Mount

Brackets by using the existing

Cab Mount Bolts removed in

step 3.

5. Place the Step Bar and the Rubber Gaskets onto the Brackets as shown (5). Each Step Bar is marked

Driver and Passenger.

6. Secure the Step Bar to each Bracket using two (2) M10 x 30MM Button Head and two (2) M10 Lock

Washers and two (2) M10 Flat Head Washers per bracket.

Tighten until the split lock washer is ﬂat against

bracket and snug. DO NOT over tighten and strip

the threaded insert in the tube.

Repeat these steps for passenger side

installation. When all hardware is in

place, everything must be tightened.

See Page 1 for Torque

Speciﬁcations.

Front

VEHICLE

FRAME

REAR BRACKET

FRONT BRACKET

STEP BAR

M10 X 30MM BUTTON

HEAD BOLT

M10 LOCK

WASHER

M10 FLAT

WASHER

CAB MOUNT BOLT

Driver Side

1601-0087, 1601-0087B

Rev 5