Installation Manual

1601-0087, 1601-0087B
5” OVAL BAR CURVED
1. Remove all contents from the package
and check all tubes for any damage. Also,
verify that all components and hardware
listed above are included before you begin
installation.
2. Read installation manual and
installation drawing completely.
Understand all brackets and bolts
before installation.
3. Begin installation on the driver’s side.
Remove the existing Cab Mount Bolts. DO
NOT DISCARD!
1
Driver Side
Components:
Driver Rear &
Passenger Front
Bracket
Qty 2
Driver Side
Step Bar -
Qty 1
Driver Front &
Passenger Rear
Bracket
Qty 2
Hardware:
Torque Specifications:
For Cab Mount Installations
Cab mount bolts are torqued to 70 Ft Lbs. All other M8 through M12 sized bolts/nuts are set to 15-20 ft lbs.
Tools Required:
Note: When installing the brackets and bars, all hardware must be left loose until all the items are attached.
RATCHET
TORQUE
WRENCH
17MM, 19MM, 21MM, 22MM
SOCKET
6MM HEX BIT
M10 Lock
Washer
Qty 8
M10 Flat
Washer
Qty 8
M10 x 30 mm
Button Head Bolts
Qty 8
Rubber
Gasket
Qty 4
Passenger Side
Step Bar -
Qty 1
1601-0087, 1601-0087B
Rev 5