Installation Manual

7. Place the Step Bar and Rubber Gaskets onto the Brackets.
Each Step Bar is marked Driver and Passenger.
8. Install the Step Bar onto each Bracket using two (2) M10 X
30MM Button Head Bolts, two (2) M10 Lock Washers and two
(2) M10 Flat Washers.
Tighten until the split lock washer is flat against bracket and
snug. DO NOT over tighten and strip the threaded insert in
the tube.
Repeat these steps for passenger side installation. When all
hardware is in place, everything must be tightened. See Page 1
for Torque Specifications.
3
7
Passenger Side
8
M10 x 30MM BUTTON
HEAD BOLT
M10 FLAT
WASHER
RUBBER
GASKET
RUBBER
GASKET
M10 LOCK WASHER
STEP BAR
Rev 5
1503-0055, 1503-0055B