Installation Manual

4. On the passenger side of the
vehicle, align the Front and Rear
brackets as shown.
5. Install the Top Flange of the
passenger side Front Bracket by
fastening two (2) M10 x 30 mm
Hex Head Bolts, two (2) M10 Flat
Washers and two (2) M10 Lock
Washers into M10 U Nut Clips.
6. Complete the installation of
the Front Bracket by using two
(2) M10 Hex Head Nuts, four (4)
M10 Flat Washers and two (2)
M10 Flat Washers. Repeat this
process for the Rear Bracket.
Hand tighten all hardware.
Note: Rear Bracket is 1/2” longer
than Front Bracket.
Passenger Side
4
6
2
5
M10 FLAT
WASHER
M10 LOCK
WASHER
M10 X 30 MM
HEX HEAD BOLT
M10 FLAT
WASHER
M10 HEX
HEAD NUT
M10 LOCK
WASHER
M10 X 30 MM
HEX HEAD BOLT
Front
FRONT
BRACKET
TOP
FLANGE
M10
U CLIP NUT
Rev 5
1503-0055, 1503-0055B