Installation Manual

1503-0055, 1503-0055B
4” OVAL BAR CURVED
1. Remove all contents from the package and
check stainless steel tubes for any damage.
Also, verify that all components and hardware
listed above are included before you begin
installation.
2. Remove the black tape and large rubber
grommets over the mounting holes located on
the inside face of the rocker panel.
3. Existing mounting holes are located on the
interior wall of the rocker panel. These mount-
ing holes will be used per the
following instruction.
On the vertical wall of each rocker panel,
install the U Nut Clips as shown for both front
and rear brackets for the top hole positions of
only. Install these U Nut Clips so that the
threads are to the inside of the rocker panel.
Be careful not to drop the U Nut Clips inside of
the rocker panel.
1
Components:
Driver Side
Step Bar
Qty 1
Passenger Side
Step Bar
Qty 1
Hardware:
M10 Flat Washers
Qty 32
M10 Lock Washers
Qty 24
M10 x30 mm
Hex Head Bolts
Qty 16
M10 U-Nut Clip
Qty 8
17MM SOCKET 6MM HEX BIT
RATCHET
TORQUE
WRENCH
Tools Required:
Torque Specifications:
For Rocker Panel Mount Installations
M8 through M12 bolts and nuts are set to 15-20 ft lbs.
Note: When installing the brackets and bars, all hardware must be left loose until all the items are attached.
M10 x 30mm Button
Head Bolt
Qty 8
M10 Hex Head Nut
Qty 8
Driver Side Rear
& Passenger Side
Front
Qty 2
Driver Side Front
& Passenger Side
Rear Bracket
Qty 2
Rubber
Gasket
Qty 4
Front
INTERIOR WALL OF
ROCKER PANEL
MOUNT HOLE
U-NUT
Rev 5
1503-0055, 1503-0055B