Installation Manual

4
6.
Place the Rubber Gaskets
onto the Brackets. Then, place
the Step Bar onto the Brackets.
Each Step Bar is marked Driver
and Passenger.
7. Secure the Step Bar to each
Bracket using two (2) M10 x
30MM Button Head Bolts and
two (2) M10 Lock Washers and
two (2) M10 Flat Washers per
bracket.
Tighten until the split lock
washer is flat against bracket
and snug. DO NOT over
tighten and strip the threaded
insert in the tube.
Repeat these steps for passen-
ger side installation. When all
hardware is in place, everything
must be tightened. See Page 1
for Torque Specifications.
7
M10 x 30MM BUTTON
HEAD BOLT
M10 LOCK
WASHER
M10 FLAT
WASHER
STEP BAR
6
Driver Side
STEP BAR
Rev 5
0804-0068, 0804-0068B