Installation Manual

3
6. Place the Step Bar and the Rubber Gaskets onto the Brack-
ets. Each Step Bar is marked Driver and Passenger.
7. Attach the Step Bar to each Bracket using two (2) M10 x
30MM Button Head Bolts, two (2) M10 Lock Washers and two
(2) M10 Flat Washers per bracket.
Tighten until the split lock washer is flat against bracket and
snug. DO NOT over tighten and strip the threaded insert in
the tube.
Repeat these steps for passenger side installation. When all
hardware is in place, everything must be tightened. See Page 1
for Torque Specifications.
6
Passenger Side
7
STEP BAR
M10 x 30MM BUTTON
HEAD BOLT
M10 FLAT
WASHER
RUBBER
GASKET
STEP BAR
Rev 5
0803-0168, 0803-0168B