Installation Manual

2
3.
On the passenger side of the vehicle,
align the Front and Rear Brackets as
shown.
4. Install the Top Flange of the Passenger
Side Front Bracket by fastening two (2)
M10 X 30MM Hex Head Bolts, two (2) M10
Flat Washers and two (2) M10 Lock Wash-
ers into the M10 U Nut Clips.
Note: For 2011 & up – only 3 Bolts are
required for Front Bracket.
5. Complete the installation of the Front
Bracket by using two (2) M10 Hex Head
Nuts, four (4) M10 Flat Washer, two (2) M10
Lock Washers and two (2) M10 Hex Head
Bolts. Repeat this procedure for the Rear
Bracket. Hand tighten all hardware.
Passenger Side
3
Front
4
M10 FLAT
WASHER
M10 LOCK
WASHER
M10 X 30 MM
HEX HEAD BOLT
FRONT
BRACKET
M10
U-NUT CLIP
TOP
FLANGE
M10 X 30 MM
HEX HEAD BOLT
5
M10 FLAT
WASHER
M10 FLAT
WASHER
M10 LOCK
WASHER
M10 HEX
HEAD NUT
Front
Rev 5
0803-0168, 0803-0168B