Installation Manual

0803-0168, 0803-0168B
5” OVAL BAR
Components:
Driver Side
Step Bar
Qty 1
Passenger Side
Step Bar
Qty 1
Rubber
Gasket
Qty 4
Front Bracket
Qty 2
Rear Bracket
Qty 2
Hardware:
M10 Flat Washer
Qty 32
M10 Lock Washer
Qty 24
M10 x 30 mm
Hex Head Bolt
Qty 16
M10 U-Nut Clip
Qty 8
17MM SOCKET 6MM HEX BIT
RATCHET
TORQUE
WRENCH
Tools Required:
Torque Specifications:
For Rocker Panel Mount Installations
M8 through M12 bolts and nuts are set to 15-20 ft lbs.
Note: When installing the brackets and bars, all hardware must be left loose until all the items are attached.
M10 x 30MM Button
Head Bolt
Qty 8
M10
Hex Head Nut
Qty 8
1. Remove all contents from the package
and check stainless steel tubes for any
damage. Also, verify that all components
and hardware listed above are included
before you begin installation.
2. Existing mounting holes are located
on the interior wall of the rocker panel.
These mounting holes will be used per
the following instruction.
On the vertical wall of each rocker panel,
install the U-Nut Clips as shown for both
front and rear brackets for the top hole
positions of only. Install these U-nut
Clips so that the threads are to the inside
of the rocker panel. Be careful not to
drop the U-Nut Clip inside of the rocker
panel.
1
Front
INTERIOR WALL OF
ROCKER PANEL
MOUNT HOLE
U-NUT
Rev 5
0803-0168, 0803-0168B