Installation Manual

1. Remove all contents from the
package and check the tubes for any
damage. Also, verify that all compo-
nents and hardware listed above are
included before you begin installation.
2. Read installation manual and
installation drawing completely.
Understand all brackets and bolts
before installation.
3. Begin installation on drivers side by
removing the existing Cab Mount Bolts
located underneath the cab of the
vehicle.
1
Driver Side
Components:
Tools Required:
Driver
Side Bar
Qty 1
Passenger
Side Bar
Qty 1
Front Bracket
Qty 2
Center Bracket
Qty 2
Rear Bracket
Qty 2
Support
Braces
Qty 2
U-Bolt
Qty 2
Rubber
Gasket
Qty 6
Hardware:
M10 x 30MM
Hex Head Bolt
Qty 2
M10 Lock
Washer
Qty 12
M10 Flat
Washer
Qty 14
M10 Flange
Lock Nuts
Qty 6
Torque Specifications:
For Cab Mount Installations
Cab mount bolts are torqued to 70 Ft Lbs. All other M8 through M12 sized bolts/nuts are set to 15-20 ft lbs.
Note: When installing the brackets and bars, all hardware must be left loose until all the items are attached.
17MM SOCKET
RATCHET
TORQUE
WRENCH
14MM SOCKET
M10 x 30 mm
Button Head Bolts
Qty 12
6MM HEX BIT
0401-0027M, 0401-0027MB
4” OVAL BAR WHEEL TO WHEEL
Rev 1-0814
0401-0027M, 0401-0027MB