RapidFit Brochure

RapidFit
®
mouldings miter as easily as traditional
mouldings and there is no need to remove existing
mouldings. Mitered corners provide a more traditional
look and they result in a smaller project bill.
Miter Install
Mitered
Outside Corner
Mitered
Outside Corner
Mitered
Inside Corner
Mitered
Inside Corner
1
2
Spacers close the
gap between the old
casing and RapidFit
®
casing, and they
provide easy alignment
of the leading edge of
the new casing.
RapidFit
®
Base
Spacers
Old Base
RapidFit
®
Casing
Spacers
Old Casing
Transition
(A simple cut on the
old base is required
for casing to extend
to ground)
(A simple cut on the
old base is required
to install a
Transition Block)
Before
After After
For use
when ONLY
upgrading
Base
Measure and
miter corners.
Place Spacers as
needed and nail
RapidFit
®
Moulding
in place.
Casing
Covers Existing Casing up to:
11/16" Th x 2-1/2" W
Base
Covers Existing Base up to:
9/16" Th x 4-1/2" W
Crown
Covers Existing Crown up to:
9/16" x 3-5/8"
Spacers close
the gap between
old base and
RapidFit
®
base.
Mitered
Door Corner
If updating
both casing and
base, casing
should be
installed first