RapidFit Brochure

Blocks add beauty and distinction to any moulding
project. RapidFit
®
blocks add beauty and reduce
installation time. They install over existing moulding and
require only straight cuts on your RapidFit
®
moulding.
Block Install
Outside
Corner
Middle
1
2
3
Inside
Corner
Rosette
Outside
Corner
Middle
Inside
Corner
Plinth
single carved
Plinth
dual carved
(A simple cut on the
old base is required
to install single
carved plinth.)
Spacers close the
gap between the old
casing and RapidFit
®
casing, and they
provide easy alignment
of the leading edge of
the new casing.
Spacers close
the gap between
old base and
RapidFit
®
base.
RapidFit
®
Base
Spacers
Old Base
RapidFit
®
Casing
Spacers
Old Casing
Transition
(A simple cut on
the old base is re-
quired to install a
Transition block)
Before
After After After
Install all RapidFit
®
Blocks as shown by
nailing into place.
Measure and cut
RapidFit
®
Moulding
to fit between
installed blocks.
Place Spacers as
needed and nail
RapidFit
®
Moulding
in place.
Casing
Covers Existing Casing up to:
11/16" Th x 2-1/2" W
Base
Covers Existing Base up to:
9/16" Th x 4-1/2" W
Crown
Covers Existing Crown up to:
9/16" Th x 3-5/8" W
For use
when ONLY
upgrading
Base
For use
when upgrading
both casing and
base. No cuts
required.