Product Manual

Split Ring
(2) ORings
Nut
no paste or teon tape
required on tting nuts
3) PUSH the tting onto the
tubing and fully against the
shoulder of the tting (soapy
water will help this process)
5) TIGHTEN nut with wrench
a minimum of ONE FULL TURN
1) CUT the tubing square
with the cutter, ROTATING
wrist while cutting
2) BEVEL the inside of the
tubing by inserting the
reaming tool and rotating it at
least 3 full turns
Remove nut and split ring
from tting and place
on tubing
4) TURN the nut nger tight
Put a reference mark on the nut
and tting body
Tools and installation
Front of block is ported
1/4” Female NPT
WARNINGS
• Regulate system pressure to a maximum of 175 psi.
• Pressurize system slowly
• Turn off air compressor when not in use
Check local building codes before installation.
• Compressed air is dangerous if not used properly.
• Do not point compressed air source at any part of your body or at any person.
• Always use eye protection when using compressed air.
• CA PROP 65: This product contains chemicals known to the state of California to
cause cancer and birth defects or other reproductive harm.
Engineered Specialties, LLC • Arpin, WI • 800-954-3310
For installation tips and warranty information, please visit www.RapidAirproducts.com
10-2011 REV1
M3800 MASTER KIT PARTS LIST
- 100ft 1/2” Maxline Tubing
- (1) M38220 Manifold Block
- (3) 90120 Outlet Blocks
- (6) M8001 1/2” Tubing x 3/8” NPT ttings
- (1) M8002 ½” Tubing x ½” NPT Fitting
- (4) 50135 3/8” npt Plugs
- (3) 50120 3/8” npt Drain Valves
- (3) 50130 3/8” 45 Deg Brass St. Elbows
- (1) M8010 Tee Fitting
- (5) M8080 Elbow Fittings
- Cutter and Bevel Tool