Product Manual

Split Ring
(2) ORings
Nut
no paste or teon tape
required on tting nuts
PLANNING/LAYOUT
Before beginning the installation, create a plan as to the location of the air compressor and where you are
going to mount the compressed air outlets. On the plan locate outlets, tees, and elbows if needed.
AIR COMPRESSOR
Use a exible jumper hose from the air compressor to the lter regulator unit to reduce vibration to the
Maxline tubing.
FILTER REGULATOR
Maxline tubing is resistant to most common petroleum based compressor oils. Some new synthetic oils
will reduce the life of the tubing. A high quality lter regulator is recommended to catch oils
entering the air system.
PRESSURE RATINGS
The Maxline tubing is rated for 175 psi at 70 deg F and less, 140 psi at a maximum temperature of 140 deg F.
BENDING THE TUBING
The Maxline tubing can be bent to
hold any shape. Care should be
taken not to kink the tubing,
but rather bend the tubing in a
sweeping radius around
corners and obstacles.
Elbow ttings are available for
sharp corners.
ASSEMBLY OF THREADED
COMPONENTS
Apply pipe sealant/paste to all
threaded connections, except
tting nuts during assembly.
TUBING INSTALLATION
Maxline tubing will expand and
contract slightly with changes
in temperature. Use supplied
wall clips spaced every 5 ft.
3) PUSH the tting onto the
tubing and fully against the
shoulder of the tting (soapy
water will help this process)
5) TIGHTEN nut with wrench
a minimum of ONE FULL TURN
1) CUT the tubing square
with the cutter, ROTATING
wrist while cutting
2) BEVEL the inside of the
tubing by inserting the
reaming tool and rotating it at
least 3 full turns
Remove nut and split ring
from tting and place
on tubing
Tools and installation
Front of block is ported
1/2” NPT Female
Coupler Not Included
WARNINGS
• Regulate system pressure to a maximum of 175 psi.
• Pressurize system slowly
• Turn off air compressor when not in use
Check local building codes before installation.
• Compressed air is dangerous if not used properly.
• Do not point compressed air source at any part of your body or at any person.
• Always use eye protection when using compressed air.
• CA PROP 65: This product contains chemicals known to the state of California to
cause cancer and birth defects or other reproductive harm.
Engineered Specialties, LLC • Arpin, WI • 800-954-3310
For installation tips and warranty information, please visit www.RapidAirproducts.com
M7500 MASTER KIT PARTS LIST
- 100ft ¾” Maxline Tubing
- (3) M81010 Aluminum Blocks
- (3) M8005 ¾” Tubing x 1/2” NPT ttings
- (3) 50136 ½” npt Plugs
- (3) 50120 3/8” npt Drain Valves
- (1) M8003 ¾” Tubing x ¾” NPT Fitting
- (2) M8011 Tee Fittings
- (20) Tubing Clips
- Cutter and Bevel Tool
10-2011 REV1
4) TURN the nut nger tight
Put a reference mark on the nut
and tting body