Product Manual

Split Ring
(2) ORings
Nut
no paste or teon tape
required on tting nuts
(2) ORings
Nut
Nut
(2) ORings
Nut
Split Ring
Split Ring
no paste or teon tape
no paste or teon tape
required on tting nuts
no paste or teon tape
required on tting nuts
no paste or teon tape
required on tting nuts
3) PUSH the tting onto the
tubing and fully against the
shoulder of the tting (soapy
water will help this process)
5) TIGHTEN nut with wrench
a minimum of ONE FULL TURN
1) CUT the tubing square
with the cutter, ROTATING
wrist while cutting
2) BEVEL the inside of the
tubing by inserting the
reaming tool and rotating it at
least 3 full turns
Remove nut and split ring
from tting and place
on tubing
4) TURN the nut nger tight
Put a reference mark on the nut
and tting body
Tools and installation
M3810
Front of block is ported
1/4” Female NPT
M7510, M8101
Front of block is ported
1/2” NPT Female
Coupler Not Included
M8200, M8201
Front of block is ported
1/2” NPT Female
(X 2)
WARNINGS
• Regulate system pressure to a maximum of 175 psi.
• Pressurize system slowly
• Turn off air compressor when not in use
Check local building codes before installation.
• Compressed air is dangerous if not used properly.
• Do not point compressed air source at any part of your body or at any person.
• Always use eye protection when using compressed air.
• CA PROP 65: This product contains chemicals known to the state of California to
cause cancer and birth defects or other reproductive harm.
Engineered Specialties, LLC • Arpin, WI • 800-954-3310
For installation tips and warranty information, please visit www.RapidAirproducts.com
10-2011 REV1
Outlet Assemblies