Brochure

SADDLE DROP INSTALLATION
STEP 1 STEP 2 STEP 3 STEP 4
MAIN SIZE DRILL BIT GASKET
1”
9
/16 ” F0043
F2210C
2” F5210C
1
1
/2”
3
/4” F0044
3
/4”
3
/4”
F0044
3” F4210C
F0044
F4210C
1) Position saddle drop opposite the side of the pipe that needs the hole
3) Insert the saddle drop gasket into the molded cavity
2) Drill thru one side of pipe with the drill bit, using the hole in the fitting as a locator
4) Position the saddle drop over the drilled hole with aligning marks, tighten securely
5) Attach the necessary drop pipe or threaded adapter
Fastpipe 3” saddles are aluminum die cast and use a different
style compression nut and inner parts than the standard Fastpipe fittings.
SADDLE DROP INSTALLATION TIPS
-system must be de-pressurized before installing, wear eye protection
-the drop can be used in any position on the pipe
-avoid putting the hole at the bottom of the pipe to prevent condensate or debris to enter the drop pipe
-to prevent chips from entering the pipe interior, stop drilling occasionally and blow out chips, grease the
end of the drilling tool
-allen wrench for tightening is 6mm size
FITTINGS PARTS BREAKDOWN
A) O-RING (Tension)
B) BACKER
C) SS BITE RING
D) COLLET
E) O-RING (Sealing)
F) CONE NUT
SPARE PARTS KIT (INCLUDES A,C AND E)
SIZE PART NUMBER
1” FI2076
3/4” FI1076
A
B C
E
D
F
- 10 - - 11 -
A great alternative for drops and long continuous
runs, see our website for more details.
• 1/2”, 3/4”, 1”, 2”
• Multi-Layer Semi Flexible tubing
• Inner and Outer Layer - HDPE
• Center Layer - Aluminum
• Sizes measured on inside diameter