Installation Manual

8
1.
Push the release lever unl it is caught
by the release stopper.
Release leverRelease stopper
2. Remove the wire coil.
3.
Push the reel stopper to release the
reel stay and open it at the same me,
remove the wire coil.
4. Load new wire coil (refer to previous
instrucons for loading wire coil).
5. Perform a test e, to check if the e
tension of set correctly.
Wire
Pipe
Reel stay
Reel stopper
6. Make sure that the wire is ght and rm.
Prevent the wire from curling up behind
the wire coil. This may cause a jam.
7. Insert baery into machine baery slot
and set the main switch to ON. Release
the trigger lock before starng to e.
Replacing Wire Coil
Warning - Ensure trigger lock is on, power is
switched o and baery removed.
5. Push the release stopper and make sure
Feeding gears Release lever
Release stopper
that the release lever is back in original
posion, and that the feeding gears are
clamping the wire.
If the window is dirty and it is dicult to
determine the posion of the Wire Guide C,
clean the inside of the window with a so
cloth. Close the window again to prevent the
ingress of foreign bodies in the machine.