Installation Manual

7
4.
Insert the p of the wire into wire guide C,
through the gap of the feeding gears and
all the way into the pipe (10-20 mm).
4. Machine Operaon
Always read, underst
and and comply with
safety instrucons (Secon 2) before use.
Baery Saving Funcon
The machine is equipped with a baery
saving funcon and will automacally shut
down after 10 minutes of no use.
Tie Tension and Wrap Settings
The first digit on the LED screen indicates the
number of tie wraps and the second digit
indicates the tie tension as shown below.
Release leverRelease stopper
Reel stopper
Reel stay
1.
Push the release lever unl it is caught by
the release stopper.
2. Push the reel stopper to open the reel stay.
10-20mm
Pipe
Wire guide C
3. Insert the wire coil with the wire-end
upwards and forward. Carefully close the
reel stay and secure the reel stopper.
Loading Wire Coil
Warning - Ensure trigger lock is on, power is
switched off and battery removed.
Press the
buon to loosen and press the
button to tighten the tie tension (1 = min
tension / 9 = max tension). By default
RT-40A is set for 3 wraps and RT-60A is set
for 4 wraps. To adjust the number of wraps
down to 2 for RT-40A and 3 for RT-60A,
switch the machine o, pull and hold the
trigger while switching the machine on. If the
machine is switched o, the number of wraps
will be automacally set for default number
of wraps again.
It is recommended to use the following guide
for wrap and tension sengs:
Model 2 Wraps 3 Wraps 4 Wraps
RT-40A 1-5 6-9 -
RT-60A - 1-5 6-9
LED screen