Operation Manual

4. Machine Operaon
Total Tie Diameter Range
Tying Procedure
1. Ensure power is on, safety lock is o and feeding gears are closed in contact with wire.
2. Hold machine mouth over reinforcing at 45˚ to reinforcing direcon (never aempt to e
diameters outside of the prescribed diameter range in table above).
3. Press trigger for operaon.
4. Remove tool when tying is complete.
Tension Sengs
Adjust Tension Control Dial to desired seng.
1 = Lowest Tension Seng
5 = Highest Tension Seng
Installing Wire Coil - only use e wire from machine supplier
1. Ensure power is switched o, safety lock is on and feeding gears are open (press the feeding
gear lever).
2. Cut loose end of e wire to ensure wire is straight.
3. Press the reel lever to release the reel stay.
4. Posion the wire on the reel holder and close the reel stay.
5. Insert the wire into the wire guide ensuring wire is fed from the top of the coil (coil will turn
clockwise). Ensure that wire is straight when inserng.
6. Connue feeding wire unl p of wire appears at the end of the machine arm.
7. Release the feeding gear lever to ensure feeding gears are closed in contact with wire.
8. Install baery.
9. Turn power on and switch safety lock o for use.
Alternave Method
1-5. Same as above.
6. Connue to feed wire at least 2cm into wire guide.
7. Release the feeding gear lever to ensure feeding gears are closed in contact with wire.
8. Install baery.
9. Turn power on and switch safety lock o.
10.Press trigger to complete loading of wire.
11.Shake completed loose e wire from machine mouth (never put hands in mouth of machine).
Machine is now ready for use.
Removing Wire Coil
1. Press the feeding gear lever to ensure feeding gears are open.
2. Remove wire from machine.
3. Press the reel lever to release the reel stay.
4. Remove the empty coil.
Model RT-40 RT-60
Total Tie Diameter Range (mm) 4-40 30-60