Specification

Concrete Pharmacy® SET Control® — DATASHEET

Concrete Pharmacy® SET Control® - DATASHEET [Printable PDF]

PRODUCT DESCRIPTION:

Designed for use with Rapid Set® cement products and most other packaged hydraulic cements, SET

Control® slows down the setting time of cement allowing you more time to place and finish your

concrete, mortar, and grout materials. This extra time is often needed when making large or intricate

placements (more than one cubic foot) of grout, mortar, or concrete. In warm weather when cement

naturally sets faster, SET Control® works to slow down the hardening of the cement.

USE:

With Rapid Set® Mortar Mix (55-lb. bag), Grout (55-lb. bag), Concrete (60-lb. bag), and DOT Repair Mix

(55-lb. bag), 1 packet of SET Control® will extend the setting time by about 20 minutes in normal

conditions. A trial batch is recommended to fine-tune the setting time to match job-site conditions.

Using SET Control® as recommended here does not reduce long-term strengths.

DIRECTIONS:

Dissolve SET Control® in the mixing water. Use enough SET Control® to achieve desired setting

requirements. Follow product mixing instructions described on the package of the cement product. Do

NOT exceed 4 packets per 50- to 60-lb. bag of Rapid Set®.

WARNING:

May cause skin, eye, and lung irritation. Avoid contact with skin, eyes, and clothing. Wash thoroughly

after handling. Wear appropriate safety and protective equipment. DO NOT TAKE INTERNALLY. In case

of contact, flush affected areas with water for 15 to 20 minutes. If irritation persists, seek medical

attention. Wash contaminated clothing. Refer to Material Safety Data Sheet for more information.

LIMITED WARRANTY:

Seller warrants this product is free from defects in material and workmanship and this warranty will be

limited to replacement of the product. IT IS EXPRESSLY AGREED THAT THIS LIMITED WARRANTY IS IN

LIEU OF ALL OTHER WARRANTIES OF FITNESS AND MERCHANTABILITY.

e 1 of 1Concrete Pharmac

® — Set Control® Additive — Data

10/26/2010htt

://www.ctscement.com/Set

data.as