SDS

Rapid Set OnePass
922491 Version #: 01 Revision date: - Issue date: 08-October-2014
SDS US
4 / 6
8. Exposure controls/personal protection
Occupational exposure limits
US. ACGIH Threshold Limit Values
Components Type
Value
Vinyl acetate (CAS
108-05-4)
STEL 15 ppm
TWA 10 ppm
US. NIOSH: Pocket Guide to Chemical Hazards
Components Type
Value
Vinyl acetate (CAS
108-05-4)
Ceiling 15 mg/m3
4 ppm
Biological limit values
No biological exposure limits noted for the ingredient(s).
Appropriate engineering
controls
Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates
should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation,
or other engineering controls to maintain airborne levels below recommended exposure limits. If
exposure limits have not been established, maintain airborne levels to an acceptable level.
Ventilation should be sufficient to effectively remove and prevent buildup of any dusts or fumes
that may be generated during handling or thermal processing. If engineering measures are not
sufficient to maintain concentrations of dust particulates below the Occupational Exposure Limit
(OEL), suitable respiratory protection must be worn. Eye wash facilities and emergency shower
must be available when handling this product.
Individual protection measures, such as personal protective equipment
Eye/face protection
Wear safety glasses or safety goggles unless full face respirator is in use.
Skin protection
Hand protection
Wear appropriate chemical resistant gloves.
Other
Wear appropriate chemical resistant clothing. Use of an impervious apron is recommended.
Respiratory protection
Use a NIOSH/MSHA approved respirator if there is a risk of exposure to dust/fume at levels
exceeding the exposure limits.
Thermal hazards
Wear appropriate thermal protective clothing, when necessary.
General hygiene
considerations
When using, do not eat, drink or smoke. Always observe good personal hygiene measures, such
as washing after handling the material and before eating, drinking, and/or smoking. Routinely
wash work clothing and protective equipment to remove contaminants. Observe any medical
surveillance requirements.
9. Physical and chemical properties
Appearance
Physical state
Solid.
Form
Powder.
Color
Tan.
Odor
Low.
Odor threshold
Not available.
pH
11 – 12 when wet
Melting point/freezing point
Not applicable.
Initial boiling point and boiling
range
Not applicable.
Flash point
Not applicable.
Evaporation rate
Not applicable.
Flammability (solid, gas)
Non combustible.
Upper/lower flammability or explosive limits
Flammability limit - lower
(%)
Flammability limit - upper
(%)