MSDS

Rapid Set Cement All
922488 Version #: 01 Revision date: - Issue date: 07-October-2014
SDS US
4 / 8
Individual protection measures, such as personal protective equipment
Eye/face protection
Wear safety glasses or safety goggles unless full face respirator is in use.
Skin protection
Hand protection
Wear appropriate chemical resistant gloves.
Other
Wear appropriate chemical resistant clothing. Use of an impervious apron is recommended.
Respiratory protection
Use a NIOSH/MSHA approved respirator if there is a risk of exposure to dust/fume at levels
exceeding the exposure limits.
Thermal hazards
Wear appropriate thermal protective clothing, when necessary.
General hygiene
considerations
When using, do not eat, drink or smoke. Always observe good personal hygiene measures, such
as washing after handling the material and before eating, drinking, and/or smoking. Routinely
wash work clothing and protective equipment to remove contaminants. Observe any medical
surveillance requirements.
9. Physical and chemical properties
Appearance
Physical state
Solid.
Form
Powder.
Color
Tan.
Odor
Low.
Odor threshold
Not available.
pH
11 – 12 when wet
Melting point/freezing point
Not applicable.
Initial boiling point and boiling
range
Not applicable.
Flash point
Not applicable.
Evaporation rate
Not applicable.
Flammability (solid, gas)
Non combustible.
Upper/lower flammability or explosive limits
Flammability limit - lower
(%)
Flammability limit - upper
(%)
Not applicable.
Not applicable.
Vapor pressure
Not applicable.
Vapor density
Not applicable.
Relative density
2.7-3.1 @ 20°C
Solubility(ies)
Solubility (water) Not available.
Partition coefficient
(n-octanol/water)
Not applicable.
Auto-ignition temperature
Not applicable.
Decomposition temperature
2460 °F (1350 °C)
Viscosity
Not applicable.
Other information
Bulk density 60 lb/ft³
Partition coefficient
(oil/water)
Not applicable.
VOC (Weight %)
0 g/l when mixed with water