RAPID TOUCH WITH BASE OPERATING INSTRUCTIONS MODELS RTB (6-15-01) RAPID-AIR CORPORATION 4601 KISHWAUKEE ST. • ROCKFORD, IL 61109-2925 Phone: (815) 397-2578 • Fax: (815) 398-3887 • Web Site: www.rapidair.
SC SERIES POWERED STRAIGHTNER RTB TOUCH INSTALLATION LOOP CONTROL The straightener that control you justisreceived fullytoassembled and tested and ready to be put factory into poThe RTB touch loop shippedisready be put into service. It was tested at the sition.
OPERATING INSTRUCTIONS RTB (RAPID TOUCH WITH BASE) Part number 10900534 (with D-sub plug) Part number 10900535 (with amp plug) INSTALLATION: The RTB unit, when received should be checked for shipping damage. If damage has occurred, contact the carrier that handled the shipment first and then Rapid-Air to report the damage. The RTB unit is shipped pre-tested and adjusted to a working height of 42” and is set for payout operation.
OPERATION: PAYOUT MODE With the RTB in place and electrically attached to the Reel, Straightener, or Rapid Roll that is in the “ON” position the unit is ready for operation. To start thread up, press the jog button of the Reel, Straightener, or Rapid Roll to feed material out so the operator has material to work with. Once there is enough material, the operator can release the jog button and put the Reel, Straightener, or Rapid Roll in automatic and let the sensor take over.
ADJUSTMENTS PAYOUT/REWIND SWITCH: In the payout mode, the device that is receiving the signal from the RTB will increase in speed as the depth of the loop becomes smaller. In rewind mode, the device that is receiving the signal from the RTB will increase in speed as the depth of the loop becomes larger. NO STOCK This relay has a contact controlled by an external switch. The switch should be mounted near the RTB and wired to the unit.
