Operation Manual

en-53
6 CONTROLS
N
P
R
S
6.2M LEFT HAND UNIT LIFT/LOWER SWITCH __________________________________
To lower the cutting unit move the switch lever forward.
To raise the cutting unit move the switch lever rearwards
NOTE:
The Yellow PTO LED will illuminate when the PTO is
selected. The Green LED indicates the unit is below
400mm, therefore with both are illuminated the reel will be
rotating.
If the lever is pulled momentarily rearwards the unit will
raise to the cross cut position and continue to rotate for 3
seconds. Lowering the unit within 3 seconds will let the reel
continue rotating without stopping.
If the lever is held and the unit lifts above the cross cut position the
unit will continue to lift and the reel will stop rotating at 400mm. The lift will stop when the lever is released.
6.2N, P, R, SINDICATOR LAMPS ______________________________________________
N PTO engaged
P Right hand cutting unit in cutting position.
R Centre hand cutting unit in cutting position.
S Left hand cutting unit in cutting position.
6.2T WEIGHT TRANSFER BUTTON ___________________________________________
To activate press and hold button.
If poor traction is anticipated due to localized ground
conditions, use of this control will provide weight transfer to
the traction wheels.