Operation Manual

en-48
6 CONTROLS
15
22°
6.2J.7 SLOPE WARNING SCREENS __________________________________________
NOTE
The slope warning screens will only become visible when the TST is
installed.
During work, if the machine is driven onto a slope of more than 16º the
screen will display this warning which over rides all other information,
and will continue until the machine has been driven to an area of less
than 16º.
If the slope angle reaches 18º, the screen will display this warning that
indicates that the cutting unit arms are locked in the lower position. An
audible warning will be given, the buzzer will sound four times every
four seconds and the red LED’s will flash four times every four
seconds. This will continue until the machine has been driven to an
area of less than 16º.
If the slope angle reaches 22º the screen will display this warning that
indicates that at 22deg the centre and upper unit will be raised 4"- 6”
above the ground to improve stability and all units stop rotating. An
audible warning will also be given, the buzzer will sound four times
every four seconds and the red LED’s will flash four times every four
seconds. This continues until the machine has been driven to an area
of less than 16º.
15
16°
15
18°