Operation Manual

en-43
6 CONTROLS
123
6.2.E CUTTING SWITCH ____________________________________________________
To commence cutting ensure speed limiter is in mow
position and the units have been lowered.
Push bottom of the rocker switch and move joystick
towards the lower position.
To stop cutter unit rotation push top of rocker switch.
Cutting units stop rotating automatically when raised or the
operator leaves the seat.
6.2.F BACKLAP SWITCH (SPORT 200 AND MAGNA 250 ONLY) ____________________
Switches the direction of cylinder rotation to allow
backlapping.
By sliding back the orange button on the rocker switch on
the control panel and depressing the switch backlap is
engaged. When backlapping is complete return switch to
normal operating position and the lock will engage.
6.2.G 4 WHEEL DRIVE IN REVERSE SWITCH ___________________________________
Engages 4 wheel drive whilst the vehicle is reversing. The
switch must be held to engage.
6.2.H LIGHT SWITCH (OPTIONAL) ____________________________________________
Switches the road lights on and off.
Position 1. OFF
Position 2. Side / Marker Lights
Position 3. Main Beam.
Note; Position 3 requires ignition to be on.