Operation Manual

en-26
7 OPERATION
7.3.6 CONNECT THE HYD 5/7 QUICK RELEASE COUPLINGS. ___________________
1. Connect the Quick Release Couplings. (A) Two
Large Couplings (Cutting Circuit Pressure/Return),
Two Small Couplings (Motor Drain/Unit 2/3 Lift). If
the connectors do not easily connect together there
is excess pressure in the circuit.
ENSURE UNITS 2/3 ARE LOCKED IN THE RAISED
POSITION OR FULLY LOWERED BEFORE
CONNECTING THE LIFT.
7.3.7 CONNECT THE HYD 5/7 TO TRACTOR QUICK RELEASE COUPLINGS ________
1. Connect the Quick release couplings. (A) The
couplings need to be connected to the Tractor
Auxiliary Valves. The pressure port on the Hyd 5/7 lift
valve can be identified by a (P) stamped into the Lift
Valve Block.
DAMAGE COULD BE CAUSED BY CONNECTING QUICK
RELEASE COUPLINGS INCORRECTLY.
7.3.8 CONNECTING THE ELECTRICAL MULTI-PLUG ___________________________
1. Carefully connect the Hyd 5/7 Multi-Plug and lock
together. (A) Care should be taken not to damage the
connector terminals.
7.3.9 CONNECTING THE ELECTRICAL AUXILIARY POWER PLUG (3 PIN) _________
1. Carefully connect the Hyd 5/7 Auxiliary Power Plug to
the tractor 25 amp Auxiliary Power Socket (A).