Operation Manual

en-20
6 CONTROLS
6.1 CONTROL BOX _______________________________________________________
The Hyd 5/7 control box will only operate
when the control box power lead and multi-
plug are connected and the tractor ignition
switch is on.
Controls:
A: Lift/Lower Units 1/2/3. Pull towards you and hold to
raise, and push away from you to lower. When
cutting the switch should be in the lower position.
Central position is neutral.
B: Lift/Lower Unit 4. Pull towards you and hold to raise,
and push away from you to lower. When cutting the
switch should be in the lower position. Central
position is neutral.
C: Lift/Lower Unit 5. Pull towards you and hold to raise,
and push away from you to lower. When cutting the
switch should be in the lower position. Central
position is neutral.
D: Lift/Lower Unit 6. Pull towards you and hold to raise,
and push away from you to lower. When cutting the
switch should be in the lower position. Central
position is neutral.
E: Lift/Lower Unit 7. Pull towards you and hold to raise,
and push away from you to lower. When cutting the
switch should be in the lower position. Central
position is neutral.
F: Mow Switch. This switch starts the cutting cylinders
rotating once the units have been lowered to the
ground.
G: Cutting Cylinder Rotation Control Switch. This switch has three positions, in its central, neutral position the
cutting cylinders will not rotate. By moving the switch to the left the cutting units will rotate forward for
cutting. By moving the switch to the right (Whilst operating the Safety Lock) the cutting cylinders will rotate
in reverse for backlapping or blockage clearance.
NOTE: When cutting units are lowered to the ground they will not rotate until the mow switch has been operated.
The mow switch may not operate at low PTO revs, and also may need to be held for a few seconds until all
units are rotating.
MOW SWITCHCUTTING CYLINDER
ROTATION
CONTROL SWITCH
CUTTING UNIT LIFT/LOWER
CONTROL SWITCHES