Instruction Manual

Air Line Heater / Filter Heater - Introduction

Ransburg

LN-9811-14.1

Note(s):

1. Outlet temperatures as noted above are based upon an inlet temperature of 68°F (20°C).

2. Heater should only be installed on a suitably fused electrical supply line. Please see

“Specications” for recommended fuse size.

3. Intelligent, thermostatic control will maintain outlet temp as inlet temp and ow rate uctuates

as long as capacity of heater is not exceeded.

4. Maximum temperature of 248°F (120°C) limited by built-in thermal overload device.

5. Chart reects power off condition when ow is shut off to unit.