Manual

LN-9217-00.2
AdaptaFlow Node Adapter - Installation
An 82 ohm resistor is provided on the Interface Board to terminate the RIO cable. Where the RIO cable
is daisy-chained to more than one Node Adapter, only the last connection point in the daisy-chain should
be terminated by moving the associated switch to the “TERM” position.
Figure 5: Node Adapter InterfaceFigure 5: Node Adapter Interface
Figure 5: Node Adapter InterfaceFigure 5: Node Adapter Interface
Figure 5: Node Adapter Interface
From PLC I/O CableFrom PLC I/O Cable
From PLC I/O CableFrom PLC I/O Cable
From PLC I/O Cable
Blue
Shield
Clear
To Node AdapterTo Node Adapter
To Node AdapterTo Node Adapter
To Node Adapter
Interface (RIO)Interface (RIO)
Interface (RIO)Interface (RIO)
Interface (RIO)
BLU
SHLD
CLR
1010
1010
10
PLC Remote I/O Cable ConnectionsPLC Remote I/O Cable Connections
PLC Remote I/O Cable ConnectionsPLC Remote I/O Cable Connections
PLC Remote I/O Cable Connections
ARCHIVE