User Manual

9060 Cascade Low Voltage Controller - Wiring Configurations
CP-13-02.3 52
Remote Analog Current Control (Sourcing Configuration)
The following example configuration uses the following:
• Sourcing Configured Digital Inputs (Apply 24VDC to activate the input)
• Permanently Wired into Remote Mode (Jumper Wire from TB3-6 to TB4-4)
• Normally Open (NO) Contact to Activate Reset when unit is Faulted
• Normally Open (NO) Contact to Activate HV Trigger to turn on HV Cascade
• 0-20mA Analog Current Control Signal
Figure 45: Remote Analog Current Control (Sourcing Configuration)