Owner's manual

9060 High Voltage Controller - Wiring Configurations
CP-13-05.3 54
Remote Analog Voltage Control (Sinking Configuration)
The following example configuration uses the following:
• Sinking Configured Digital Inputs (Apply GND to activate the input)
• Permanently Wired into Remote Mode (Jumper Wire from TB3-11 to TB3-2)
• Normally Open (NO) Contact to Activate Reset when unit is Faulted
• Normally Open (NO) Contact to Activate HV Trigger to turn on HV Cascade
• 0-10V Analog Voltage Control Signal
Figure 47: Remote Analog Voltage Control (Sinking Configuration)