User Manual

CP-97-04.3
2121
2121
21
9040 Cascade Low Voltage Control Unit - Operation
>>
>>
> The user
MUSTMUST
MUSTMUST
MUST read and be familiar with
the
SAFETY PRECAUTIONS andSAFETY PRECAUTIONS and
SAFETY PRECAUTIONS andSAFETY PRECAUTIONS and
SAFETY PRECAUTIONS and
SAFETY SECTIONSSAFETY SECTIONS
SAFETY SECTIONSSAFETY SECTIONS
SAFETY SECTIONS of this manual and
the ITW Ransburg safety literure therein
identified
BEFORE OPERATINGBEFORE OPERATING
BEFORE OPERATINGBEFORE OPERATING
BEFORE OPERATING the 9040
Cascade control unit.
W A R N I N GW A R N I N G
W A R N I N GW A R N I N G
W A R N I N G
!!
!!
!
OPERAOPERA
OPERAOPERA
OPERA
TIONTION
TIONTION
TION
>>
>>
> The electrical discharge that is available
from the charging electrode of the applicator
must not exceed 0.25 mJ of energy. To
achieve this limit, any flow of energy from the
paint supply through the paint line to the
applicator electrode must be prevented by
grounding the paint line at the applicator
handle or body.
> >
> >
> Verify that the applicator is actually
grounded before operating it! (See the
appropriate applicator manual.) If improper
readings are obtained, check that the control
unit is grounded. (See “Ground Test
Procedures” in the “Maintenance -
Troubleshooting” section of this manual.)
W A R N I N GW A R N I N G
W A R N I N GW A R N I N G
W A R N I N G
!!
!!
!
Figure 8: Operating ControlsFigure 8: Operating Controls
Figure 8: Operating ControlsFigure 8: Operating Controls
Figure 8: Operating Controls
ARCHIVE