User Manual

ManualsBrandsRansburg ManualsEquipment9040 Cascade LV Control Unit 76580

CP-97-04.3

9040 Cascade Low Voltage Control Unit - Installation

> The 9040 Cascade control unit

MUSTMUST

MUST be

located outside the hazardous area. (See

NFPA-33, OSHA, and ITW Ransburg

Literature “Operating Your Electrostatic

Coating System Safely”.)

> The user

MUST MUST

MUST read and be familiar with

the SAFETY and SAFETY PRECAUTIONS.

> This manual MUST be read and thoroughly

understood by ALL personel who operate,

clean, or maintain this equipment! Special

care should be taken to ensure that the

WARNINGS and requirements for operating

and servicing safely are followed. The user

should be aware of and adhere to ALL local

building and fire codes and ordinances as

well as NFPA-33 and OSH prior to installing,

operating, and/or servicing this equipment.

W A R N I N GW A R N I N G

W A R N I N G

> As each installation is unique, this

information is intended to provide

gener-gener-

gener-

alal

installation information for the 9040

Cascade control unit. Consult your au-

thorized ITW Ransburg representative

for

specificspecific

specific

directions pertaining to the

installation of your equipment.

NOTENOTE

NOTE

LOCALOCA

LOCA

TIONTION

TION

Install the 9040 Cascade control unit in an area

outside the hazardous location, where it will be

protected from the possibility of environmental

intrusion, such as dust or moisture, and ambient

temperatures do not exceed 120°F, but as close

to the applicator as possible to minimize the length

of low voltage cable. The control unit may be free

standing on any flat surface or rack mounted in

any 19-inch or Eurorack cabinet.

DO NOTDO NOT

DO NOT locate the control unit near

or adjacent to heat producing equipment

such as ovens, high wattage lamps, etc.

C A U T I O NC A U T I O N

C A U T I O N

> When rack mounting the 9040 Cas-

cade control unit in a 19-inch cabinet or

Eurorack, it may be necessary to remove

the rubber feet from the bottom of the

9040 enclosure.

NOTENOTE

NOTE

INPUT CONNECTIONSINPUT CONNECTIONS

INPUT CONNECTIONS

For non-conduit installations, plug the detachable

AC line cord into the receptacle in the rear of the

9040 Cascade control unit. Plug the other end of

the line cord into a properly grounded 120-volt AC

outlet.

> In general, conduit must be used for

approved AC installation; however, if na-

tional and local codes permit, the AC

power may be supplied via the factory

supplied line cord. If conduit is utilized,

the control unit AC input wiring may be

routed through an optional explosion proof

switch mounted on or near the spray

booth where it will be convenient to the

operator.

NOTENOTE

NOTE

INSTINST

INST

ALLAALLA

ALLA

TIONTION

TION