Product Manual
35
4. Press the Inflation Pedal six times to work the oil into
the Valve. (See Fig 15.19)
TRANSMISSION INSPECTION / LUBRICATION
1. Rotate the Turntable so that the Transmission fill plug is
visible and remove plug. (See Fig. 15.20)
2. Put a flexible wire into the Transmission Oil Fill Hole until
the wire hits the bottom of the well. (See Fig 15.21)
3. Remove the wire and check the capacity level of the
Transmission fluid. The oil should cover no more than 1”
( 25 mm) of the wire.
NOTE:
Gearbox Requires
90 Plus Viscosity Gear Oil
FILLING OIL LEVEL HIGHER WILL RESULT IN
LEAKAGE OF THE TRANSMISSION SEALS.
BE SURE TO READ ALL WARNING LABELS AND
INSTRUCTION MANUAL PRIOR TO OPERATION OF
THIS MACHINE. FAILURE TO COMPLY WITH PROPER
SAFETY INSTRUCTIONS MAY LEAD TO SERIOUS
HARM OR EVEN DEATH OF OPERATOR AND/OR
BYSTANDERS.
ALWAYS INSPECT TIRES BEFORE MOUNTING.
DEFECTIVE OR DAMAGED TIRES MAY BURST OR
EXPLODE WHEN INFLATING AND MAY LEAD TO
SERIOUS HARM OR INJURY.
Fig 15.20
Disconnect Tube
and Lubricate in Port
Fig 15.18
Fig 15.19
Fig 15.21