Product Manual

AIR DRIER/OILER MAINTENANCE

AIR/WATER MAINTENANCE

Check oil and water levels regularly, and perform these

maintenance items daily:

1. Observe through the clear sight glass the oil and water

levels. (See Fig 15.4)

2. If any amount of water is observed, drain by pushing up

on the drain plug at the bottom of the reservoir. (See Fig

15.5)

OILER MAINTENANCE

1. Disconnect air supply from machine. (See Fig 15.6)

2. Reservoir Cup may be removed for cleaning by turning

the reservoir counter-clockwise and pulling down. Add oil

to the lubricator if the fluid level is below the middle of the

gauge. Unscrew the Oil Reservoir Cup, add SAE 10W non-

detergent oil or an air tool oil if necessary. (See Fig 15.7)

3. Replace the Cup and reconnect the air supply when

service/adjustments are complete.

4. With the air source connected, depress the Bead

Breaker Pedal to operate the Bead Breaker. Observe the

sight glass and adjust the oil flow of the oiler by turning the

Oiler Adjustment Screw counter clockwise so that 2-3 drops

of oil drip through the sight glass for each operation of the

Bead Breaker Pedal. (See Fig 15.8)

FAILURE TO MAINTAIN THE WATER SEPARATOR/

AIR OIL IN PROPER CONDITION MAY VOID WAR-

RANTY. DRAIN WATER OUT OF THE SYSTEM REGU-

LARLY AND KEEP THE OIL RESERVOIR FILLED.

Fig 15.4

Fig 15.5

Fig 15.6

Disconnect

Air Supply

Fig 15.7

NOTE:

THIS ADJUSTMENT WILL REQUIRE TWO PERSONS

TO PERFORM.

Fig 15.8