Product Manual

SECTION 9

AIR SOURCE

This model requires a 14 to 15 CFM air source at 175

PSI maximum pressure. The safe operating pressure

range for this model is between 110 PSI and 175 PSI

at the machine. A 1/4” ID hose (or pipe) for connection

to the machine is satisfactory. Sufficient air pressure

assures good performance.

1. Connect the Air Supply to the Air Drier / Oiler. A proper

fitting (not included) to match the supply line of the air

supply connection is required. Use Teflon tape on the NPT

thread of the fitting. This connection is located on the right

side of the rear of the machine. (See Fig 9.1)

OILER ADJUSTMENT

1. Check Oil Level on Oil Level Gauge. (See Fig. 9.2)

If Oil level is low refer to Section 15, for filling instructions.

2. With the air source connected, depress the Bead

Breaker Pedal to operate the Bead Breaker.

3. Observe the sight glass and adjust the oil flow of the

oiler by turning the Oiler Adjustment Screw by using a small

screwdriver so that 2-3 drops of oil drip through the sight

glass for each operation of the Bead Breaker Pedal. (See

Fig 9.3)

SECTION 10

ELECTRICAL SOURCE

1. This unit requires power from a 15 amp electrical circuit.

The unit is supplied standard with a 110 Volt power cord

and plug. (See Fig 10.1). Please remember that ALL F

models are standard 220 V only.

2. Refer to the serial tag of the machine for specific

electrical requirements. Have a licensed electrical techni-

cian perform any necessary changes to the power source

and power cord before plugging in the unit. The electrical

source must have a solid connection between ground and

building ground.

FAILURE TO PROPERLY MAINTAIN PROPER OIL

LEVEL AND ADJUST THE OIL FLOW MAY VOID THE

WARRANTY AND DAMAGE THE BEAD BREAKER

CYLINDER AND OTHER AIR COMPONENTS.

NOTE:

THIS ADJUSTMENT WILL REQUIRE AT LEAST TWO

OPERATORS TO PERFORM.

Fig 10.1

Fig 9.1

Fig 9.2

Fig 9.3