Product Manual

1. Inspect the wheel closely for damage. Clean the wheel

and remove any light corrosion or rubber residue. Do not

attempt to service heavily corroded wheels. (See Fig. 13.1)

2. Inspect tire for damage, paying close attention to the

beads. Verify size match between tire and wheel.

(See Fig. 13.2)

3. Lubricate both tire beads liberally with tire manufacturer’s

approved lubricant. (See Fig. 13.3)

4. Place tire over wheel and move Tower and Mount/

Demount Head into position as described earlier. Position

tire so that the lower bead is above the left side of the

Mount/ Demount Head and below the right front knob. (See

Fig. 13.4)

5. Manually force the tire down into the drop center of the

wheel directly across from the Mount/ Demount Head to

reduce the tensional force on the bead. Depress the Table

Top Pedal and rotate the wheel to mount the lower bead.

Rotate the Table Top until the lower bead is fully mounted.

(See Fig. 13.5 - 13.6)

WARNING!

THE RIM AND BEAD MUST BE LIBERALLY

LUBRICATED. FAILURE TO USE AN ADEQUATE

LUBRICANT CAN LEAD TO THE BEAD BINDING ON

THE RIM AND LEAD TO DAMAGE TO THE MOTOR

AND OR VOID THE WARRANTY.

WARNING!

If you damage the tire bead during mounting,

STOP! Remove the tire and mark it as

damaged. Do not mount a damaged tire.

Fig. 13.3

Fig. 13.4

Fig. 13.5

Fig. 13.6

Fig. 13.1

Fig. 13.2