User's Manual

- 2 -
SPECIFICATIONS
A
GENERAL
Model
ELITE ONE
Channels 40
Frequency Range 26.965 ~ 27.405 MHz
Emission AM
Frequency Control Phase-Lock-loop (PLL) Synthesizer
Frequency Stability 0.001%
Temperature Range
-30°C to +50°C
Antenna Impedance 50 Ohms
Antenna Connectors Standard SO-239 type
Input Voltage 13.8V DC
Size 190 (W) x 120 (D) x 31 (H) m/m
Weight 1 kg.
TRANSMITTER
RF Power Output
AM: 4W
Spurious Emission More than -60 dB
Audio Distortion <10%
Frequency Response 300 to 2500 Hz
Microphone CONDENSER MIC
RECEIVER
Sensitivity AM: 0.5 uV for 10dB Sinad
Squelch Sensitivity < 0.5 uV
Image Rejection More than 60 dB
AGC Figure of Merit 100 mV for 10dB Change in Audio Output
Audio Power Output 3W @ 10% Distortion
Audio Response 300 to 2500 Hz
(SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE)
- 3 -
INSTALLATION
A
LOCATION
Plan the location of the transceiver and microphone bracket before starting the installation.
Select a location that is convenient for operation and does not interfere with the drive or
passengers in the automobiles, the transceiver is usually mounted the dash panel with the
microphone bracket beside it.
MOUNTING THE RADIO
The transceiver is supplied with a universal mounting bracket. When mounting the bracket and
radio to your car, make sure it is mechanically strong. Also provide a good electrical connection
to the chassis of the vehicle. Proceed as follows to mount the transceiver:
1. After you have determined the most convenient location in your vehicle, hold the
transceiver with mounting bracket in the exact location desired. If nothing will interfere with
mounting it in the desired position remove the mounting bolts. Before drilling the holes,
make sure nothing will interfere with the installation of the mounting bolts.
2. Connect the antenna cable plug to the standard receptacle on the rear panel. Most
transceiver antennas are terminated with a type PL-259 plug and mate with the receptacle.
3. Connect the red DC power input wire (with the fuse) to +13.8V DC. This wire extends from
the rear panel. In automobile installation, +13.8V DC is usually obtained from the
accessory contact on the ignition switch. This prevent the set being left on accidentally
when the driver leaves the car and also permits operating the unit without the engine
running. Locate the accessory contact on most ignition switches by tracing the power wire
from the AM broadcast receiver in the car.
4. Connect the black lead to –13.8V DC. This is usually the chassis of the car. Any convenient
location with good electrical contact (remove paint) may be used.
5. Mount the microphone bracket on the right side of the transceiver, using two screws
supplied. When mounting in an automobile, place the bracket under the dash so that
microphone is readily accessible.